1.The most common cylinder cylinder is blocked. This is generally due to improper use. The site should always release water to the air compressor. There is a filtered bottle at the air inlet, and the water inside should be drained. Otherwise It is troublesome to enter the cylinder.

2.The correct selection of filter cloth, that is, to consider the clarity of the filtrate must also consider the filtration efficiency. The filter cloth must be cleaned once at the end of each work so that no residue remains on the surface. The filter cloth becomes hard and softened. If it is damaged, it should be repaired or replaced in time.

3.Check the sealing surface of the filter plate and remove the residue on the sealing surface to avoid leakage and leakage during operation. Pay attention to the protective sealing surface, do not collide, stand upright when placed, and reduce deformation.

4.The filter belt the common problem is torn or blocked. The filter belt tear is mostly caused by uneven force. So pay attention to the machine's correction system. If there is a problem with the correction, the filter cloth will go to the normal machine, and the life of the filter cloth will be almost the same. As for clogging, it requires frequent washing. One is to ensure a clean flushing water, and the other is to ensure sufficient flushing water pressure, preferably after washing the machine for another 5-10 minutes.

5.The bearing Because the belt machine is mainly relied on the extrusion of the roller to dehydrate. Therefore, the bearing is subjected to a large pressure, so the bearing is also a common wearing part. This requires us to pay attention to the thickness of the mud cake during mud removal. Under normal circumstances, the thickness of the mud cake of 3-5mm is the best result. Don't be too thick and hurt the bearing.