Today, Dingli introduced to you some of the error problems in the design of the potato dregs dryer. Design technicians need to design accurately when designing the potato dregs dryer. Of course, there are certain errors within the specified range.

  The standard deviation of the basic size and installation position of the potato dregs dryer equipment is as follows: the elevation error between the plane and the plane should be less than 20 mm, and only the negative error is allowed to allow positive error; the full length of the slope error is less than 20 mm. A negative error is allowed at the material end to prevent a positive error from occurring; the error between the non-planes of the upper plane should be less than 5 mm per meter and the total length should be less than 10 mm per meter. The position of the equipment part and the position of the base coordinates shall be less than 20 mm on the longitudinal and transverse axes. These dimensional errors are within the specified range, and are qualified products within this error range. Defects beyond this error range are inferior to the later production operation, and may not be completed during the assembly. . For the customer, although this size is not necessary to know so clearly, but also need to know the approximate error range, so that you can also determine whether a part is not qualified for assembly errors.